Rat Rig 3.1 Upper Rear Panel with filter port, temp sensor, and filteredexhaust

General Description:

This is the Rat Rig VCore 3.1 Upper Rear Panel 3D Printed with a 2 in. air filter port, chamber temp sensor mount, and a filtered chamber exhaust.

It uses 2 - 4i n.x4 in. Nispira 3-in-1 True HEPA Carbon Filter Cartridges or Osimo A2 Air Purifier filter cartridges. These are common filter cartridges found on Amazon or other sites.

Hardware Needed:

• 2 - Air filter cartridges

• 2 - 60mm x 20mm dc fans (12 or 24 volts)

• 16 - M6x16mm Socket head screws (attach to frame)

• 16 - M4 T-nuts

• 12 - M4x12mm Socket Head screws (filter port mount and section seams)

•  8 - M4x30mm Socket head screws (fan mount)

• 12 - M3x10mm Socket head screws (chamber filter box mount)

• 12 - M3x4mm heat inserts (install in filter box extension, both sides)

•  1 - NTC 100K 3950 generic 3mm thermistor

•  1 - 3D Printer Mainboard Y Splitter

•  2 - 1M 3D Printer Parts Cooling Fan Extension Cable 2pin Xh2.54 Connection Line Male Female

•  1 - Dust Collection hose 2 in × 10 ft Clear Flexible PVC Fume Hose with Carbon Steel Wire

•  1 - 2 Inch Stainless Steel Worm Gear clamps

The air filter, the 45 degree, and the 90 degree elbows I used are HERE.

Printing recommendations:

• The temp sensor mount: Layer 0.16mms

• There are no specific printing requirements for the remaining items. Use your normal printing settings.

Please show your support by hitting like. Thank You.