Sink Gap Cover (Sloped Drip Guard)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Covers the gap between your sink and the wall with a gently sloped surface, so water runs back into the sink.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 11
- Makes
- 0
- Views
- 118
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution
This cover sits between the sink rim and the wall. Thanks to the gentle slope, splashed water runs back into the sink instead of collecting in the gap.
The dimensions are designed around common Central European kitchen standards. The top surface is approximately 12.5 cm deep and 30 cm wide, and it is supported by a mounting lip that is 9.5 cm long and 0.5 cm high.
In some cases, adding sealing tape between the cover’s overhang and the sink rim can improve the fit and reduce water seepage.
Versions
Two-piece (grip surface): The dotted surface provides extra stability when placing items such as cutting boards.
Smooth surface: Ideal as a clean, wipeable area for kitchen helpers like sponges, brushes, and soap dispensers.
As a set, the design uses the full width of standard, commonly available sinks in Central Europe.
Printing recommendations (FDM)
Print standing on the long edge (as shown in the files)
Recommended material: PETG
Layer height: 0.20 mm
Optional: add a manual brim for better adhesion
Custom sizes
If there is sustained interest, I’m happy to adapt the design to additional sizes, dimensions, and use cases—just leave your requested adjustments in the comments :)