1 / 7
Battery Adapter 3s Li-Ion / Elecraft K1 — image 1
1 / 7

Battery Adapter 3s Li-Ion / Elecraft K1

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Use an internal 3s Li-Ion battery in your QRP radio

Rating
0 / 5
Likes
1
Downloads
12
Makes
0
Views
118
Reviews
0

Updated at source:

Model information

Category
Electronics
License
Creative Commons — Attribution — Noncommercial — Share Alike

This is a battery adapter to use a 3S Li-Ion battery instead of AA-cell or NiMH battery inside the Elecraft K1. It has the same dimensions like the original KBT1.

The top cover are easy to remove and you can charge your Li-Ion batteries with any standard charger via the DC plug.

I've made 2 versions if a Noiseblanker board is installed and another version without installed NB.

 

 Material

 PETG or better

Layer height

 ≤0,2 mm

Infill

100%

Support

Use support under the hole where the speaker is installed.

 

Description for mod:

-Glue a piece of aluminium tape on one side of the printed adapter (RF shielding)

-Remove the original aluminium battery adapter KBT1

-Unscrew the switch and attach it with the same screws and nuts to the new adapter.

-Disconnect the wiring and install a DC socket (female 5.5 x 2.1 mm) in place of the AA-cell holder. (Use cables with good insulation and shrink tubing)

Diese Anleitung ist nach bestem Wissen und Gewissen erstellt und kann Fehler enthalten. Das Nachbauen sollte nur von fachkundigen Personen durchgeführt werden und diese handeln eigenverantwortlich. Für Schäden an Gegenständen oder Personen übernehme ich keine Haftung!

These instructions have been created to the best of our knowledge and belief and may contain errors. The reconstruction should only be carried out by specialists and they act on their own responsibility. I assume no liability for damage to objects or people!

Tags