Lea the Truck

From the original post:

Summary

Model of the Lea the truck from the cartoon “Leo the Truck”.

For assembly you will need:

• 11 M3*10 screws .

• 1 M3*16 screw .

• 12 insert nuts M3 (OD 4.5 mm, length 4-6 mm) .

You can use both DIN912 hexagon socket screws and regular pan head screws, which are available in your local store.

Print Settings

• Printer brand: Flying Bear

• Printer: Flying Bear Ghost 5

• Resolution: 0.2

• Infill: 10-20%

• Filament brand: Any

• Filament material: PLA, PETG

Notes:

The parts of the model are printed at a layer thickness of 0.2 mm, but I would advise for parts of the windshield, eyebrow, bearings, eyes and nose to set a lower thickness value of 0.10-0.15 mm, this will make them more neat and durable. Number of perimeters 3, line width 0.5 mm, infilling 10-20 %.
The wheels are available in two versions, for printing with elastomers (TPU) or solid plastics (PLA, PETG). For better print quality of tires, you need to enable the "Avoid crossing perimeters" function in PrusaSlicer or "Combing" in Cura. To print wheel bearings, it is necessary to reduce the flow to 95%, set the layer thickness to 0.15 mm, and randomly place the seam. The printed bearings should be rotated and lubricated with WD40, they should work without jamming. If they still jam, then reprint with a flow of 90%. Bearing material PLA or PETG. ABS is better not to use, it has very low wear resistance. For tires, the softer the TPU, the better.
The head, windshield, eyebrow, base, body, bamper and rims are printed with supports.

See also

• Leo the Truck

• Lifty the forklift

• Scoop the Excavator

• Leo the Truck separated Base