Jonsbo N2 wall-mount bezel
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I used this frame to mount my headless NAS on a plywood wall
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 8
- Makes
- 0
- Views
- 192
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I built a small shelf for my Jonsbo N2 which runs headless in my utility room. To make sure it does not fall down, I designed this frame which holds the N2 securely.
For the shelf itself I used an MDF plate ( 239 × 250 mm² / 9.4" × 9.8") and two metal brackets; the whole setup is screwed onto a plywood board, see photos. With the alignment shown in the photos, all ventilation openings of the housing remain clear.
Note: The frame has a little opening to make room for the bottom screw on the backside. If needed, you can mirror the model within your slicer software.