Blue Robotics ROV 6" SIX Inches HOLDING CLAMPS
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Base and top Holding clamps for Blue Robotics ROV six inch aluminium watertight enclosure.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 20
- Makes
- 0
- Views
- 74
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Share Alike
4.11.2026: Added clamp base and clamp top FILLETED versions. They could offer better durability due to rounded edges being less prone to forming stress concentration points. Theoretically more hydrodynamic :)
Same terms and conditions apply as previously.
Base and top Holding clamps for Blue Robotics ROV six inch 6" aluminium watertight enclosure.
These clamps are intended for use with 163,9 mm outer diameter tubes.
Two versions: One for 3d printing, with rounded features, indentations for washers and holes for bolts. Another version, which is just flat, with no 3d features or through holes. This version is suitable for cutting from sheet material e.g. aluminium. Then you need to locate the holes yourself.
M6 screws.
I also included a drill guide to help locate bolt holes for the base clamp.
Images show a draft version printed in yellow PLA and the final version printed in white ASA.
This model has NOT been tested and I can NOT vouch for it being reliable in marine or any conditions. Use at your own peril. :)
That being said My ASA prints were printed on a core one with 0.30mm layer height, 15 perimeters and 100% infill.