Copperband Butterfly Feeder V3
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Created and made changes on others prints and made a shallow feeder with a hole on top so you dont need to remove it.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 48
- Makes
- 0
- Views
- 147
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Animals
- License
- Open Community License v1
Created and made changes on others prints and made a shallow feeder with a hole on top so you don't need to remove it.
i used 32x3mm magnets
the exact measurements for the magnets is 45mm x whatever height you want id advise to stack 45x3 but its up to you
amazon.com/dp/B072KDBJWC?ref=fed_asin_title
this is the magnets I used
Also fixed the issue where the holes were in the threads which was not supposed to be there.
Pause print around layer 115 and insert the magnets no higher than the model . I also used gorilla glue on the magnets incase the inside portion was somehow compromised and the glue will protect against corrosion.