1 / 3
Gjöra bed backrest mount
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Holder for a backrest
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 5
- Makes
- 0
- Views
- 27
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Bedroom
- License
- Creative Commons — Attribution — Noncommercial
Our Gjöra is used frontside back, because it has to fit under the ceiling.
I always missed a backrest, so I created this mount that will hold a 12mm board. I cut the board to about 43cm length so it will lean against the frame behind the matress.
It needs M5 screw and short heat-set thread inserts. Getting them in is a bit tricky, I did it with a flat soldering iron. the bore could be reduced so it works with self-tapping screws.