1 / 5
TCL TV Stand 65" — image 1
1 / 5

TCL TV Stand 65"

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

TCL 65" tv legs that use the original mounting location but bring the legs towards the center to fit on smaller tv stand

Rating
0 / 5
Likes
0
Downloads
22
Makes
0
Views
165
Reviews
0

Updated at source:

Model information

Category
Electronics
License
Creative Commons — Attribution — Noncommercial

The original 55" TV fit perfectly on its factory stand, but the new 65" S-Series TCL 4K is just wide enough that the stock legs no longer work with the existing furniture. Rather than replacing a perfectly good stand or resorting to an off-the-shelf workaround, I designed a custom set of replacement legs in Fusion 360 that pull the mounting points inward by roughly two inches. This allows the wider TV to remain fully supported while continuing to use the original stand and factory mounting locations.

The result exceeded expectations—both functionally and visually.

From the outset, I defined three core design requirements:

  1. Structural stability – The legs needed to independently support the full weight of the TV without requiring additional reinforcement or external supports.

  2. Minimal visual footprint – Aesthetics were a priority. The design keeps the legs tucked in and visually unobtrusive, maintaining a clean, streamlined appearance that doesn’t distract from the display itself.

  3. Universal compatibility – The solution exclusively uses the TV’s original mounting points. No wall mounts, adapters, or nonstandard hardware are required, ensuring the design remains accessible and easy to replicate for others.

The final product strikes a balance between practicality, stability, and refined design—delivering a purpose-built solution without unnecessary complexity.
My print settings:

Elegoo Centurion Carbon
Polymaker Polylite ABS - Purple
Build Plate: 90C
Hotend: 270C
Textured PEI

Slicer Settings:
Orca Slicer
Supports: ON
Brim: OFF
Infill: 15%
Infill Pattern: Gyroid
Perimeters: 4 (for the strength
Build Plate Layout: These legs were designed so you can print both legs at the same time on a standard 250mm^3 printer like a Elegoo Centurion Carbon, Bambulabs X1C, Ender 3, etc etc.

Tags