Odyssey Fuselage Tail Surfaces Servo Connector Holding Plug
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Varioshore plugs to hold the servo connectors in place in the factory cut holes in the fuselage
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 3
- Makes
- 0
- Views
- 26
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial
Varioshore plugs to hold the servo connectors in place in the factory cut holes in the fuselage.
Print in Varioshore TPU or equivalent to save maximum weight, nozzle temperature maximum expansion @ 250C, 50 percent flow, 0.24mm layers, 5 top and 16 bottom surfaces and 3 walls, gyroid infill @ 15%.
Cut half of the diameter over the middle of the wide part of the servo connector and use a small tie wrap to close off the end securely, wrap the circumference with one loop of electric tape over the middle of the body if needed.
Sqeeze in place and document the wire layout with a sticker next to the plug if you want or need to.