Land Rover Defender TD4 Rear Hub Seal Installer / Driver (LRT-54-003)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Seal installer/driver for Defender TD4 rear hub seal (LRT-54-003). Helps seat the seal squarely without distortion.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 27
- Makes
- 0
- Views
- 96
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- GNU General Public License v3.0
This model is a 3D-printable version of Land Rover special service tool LRT-54-003. The tool is used during rear axle hub service to install / assemble the hub seal by keeping it aligned and helping it seat squarely in the hub/bore.
If you’ve ever installed an oil seal slightly crooked, you know what happens next: distorted seal body, damaged lip, leaks, or premature wear. The whole point of this tool is to make the seal go in straight and reduce the chance of damaging the sealing surface.
Intended use (function)
Guides the seal into position so it starts straight
Helps you drive/press the seal evenly around its circumference
Minimizes the risk of:
pinching/rolling the seal lip
deforming the seal shell
installing the seal at an angle
damaging the bore or seal surface
Compatibility / notes
Intended for Land Rover Defender TD4 (“Puma”) rear hub work where tool LRT-54-003 is specified.
This is a workshop aid and is not an official Land Rover product.
Always verify fitment against your specific seal/hub revision before applying force. Land Rover variants and aftermarket seals can differ.
How to use (typical workflow)
Clean the bore and confirm there are no burrs or corrosion where the seal seats.
Lightly lubricate the seal lip / seating surface as appropriate for your service manual.
Place the seal onto/into the tool as designed (depending on your geometry).
Offer the seal to the hub and ensure it is perfectly centered and level.
Seat the seal:
If using a bench vise or press, apply force slowly and check alignment continuously.
If using a mallet, use controlled taps and watch for any sign the seal is drifting off-axis.
Stop when the seal reaches the correct depth/shoulder per the service procedure.
Printing recommendations (important!)
Because this is a functional tool that may see impact/compression loads, print settings matter:
Material: PETG recommended for general use; ABS/ASA/Nylon (or fiber-reinforced Nylon) if you expect higher loads or workshop abuse.
Infill: high (e.g., 50–100%) with strong perimeters/walls.
Walls/perimeters: increase walls to improve hoop strength.
Orientation: print in the orientation that maximizes strength around the driving face (generally with the force path aligned with layer lines as little as possible).
Test fit first: before you press/drive a real seal, do a dry run to confirm the tool seats correctly and doesn’t foul on any features.
If you plan to use significant pressing force, consider printing in a tougher material (nylon) and/or using the tool primarily as an alignment guide rather than a high-force driver.
Safety / disclaimer
This is a DIY, community-made tool. Use at your own risk. You are responsible for verifying dimensions, fit, and safe operation. I’m not affiliated with Land Rover, and this model is provided as-is with no guarantee of suitability for any specific repair.
Source files / CAD
The full source (CAD + exports + any notes) is here: