1 / 9
C&C Service Depot Phone Charger — image 1
1 / 9

C&C Service Depot Phone Charger

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

It's the repair pad from Command & Conquer/Red Alert, but it charges your phone!

Rating
0 / 5
Likes
5
Downloads
16
Makes
0
Views
246
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Share Alike

I grew up playing Command & Conquer and Red Alert and wanted to make a phone charger that looked and lit up like the repair pad, and this does exactly that! I would consider this a medium difficulty project as soldering is required. It is somewhat tedious but not difficult at all.

https://youtube.com/shorts/GAdgs-TSv6I?feature=share

(The embedded video doesn't work sometimes, not sure why)

BOM:

Print Instructions:

Print one of every part. Note that a multicolor printer is pretty much required for the Pad and Ribs, which are meant to be imported into the slicer simultaneously as components of one part. This makes setting the filament for each easier. the Ribs must be opaque while the pad must be translucent for the lighting to work right. Note that you can get away without a prime tower as the colors are so similar, I printed everything but the rim on an A1 Mini that way.

Assembly:

Wire everything up per the schematic. LED's for the outer ring are cut to 2 segments, the middle ring is one segment, and the inner ring is about 75% of a segment (they still work if you don't cut on the lines). 

Everything is powered from the 5V USB cable connected to the charger module. Connect the 5V pin on the Arduino directly to a point on the charger board that measures close to 5V (mine measured 4.3V, works fine) while something is charging. Same with Ground. The board I used had a solder pad that went LOW only when something was charging (exact opposite of the green LED), connect this to the input pin (I used 4). I used a section of protoboard to keep the transistors and resistors organized, this is probably optional.

I optimistically included 4 mounting points for the Arduino and charger board, I only ended up using 2 screws for the charger board and the Arduino is floating.

Everything can be glued but I found a friction fit to work pretty well.

Code:

//Cross Engineering
//1/7/26
//Re3pair Pad Charger

//Change the numbers to whichever you used, they must be PWM capable const int OUTER = 12; const int MIDDLE = 11; const int INNER = 10;

const int CHARGE = 4; //This can be any pin, I chose 4 out of convenience

const int DELAY = 100; //Time each ring is lit up const int PAUSE = 500; //Time between animation cycles

void setup() { pinMode(OUTER, OUTPUT); pinMode(MIDDLE, OUTPUT); pinMode(INNER, OUTPUT); pinMode(CHARGE, INPUT);

delay(5000); //The charger board does a self test on start-up where the LED's flicker, this makes the arduino wait until after that to start running }

void loop() {

if (digitalRead(CHARGE) == LOW) { analogWrite(OUTER, 255); analogWrite(MIDDLE, 0); analogWrite(INNER, 0); delay(DELAY); analogWrite(OUTER, 127); analogWrite(MIDDLE, 255); analogWrite(INNER, 0); delay(DELAY); analogWrite(OUTER, 0); analogWrite(MIDDLE, 127); analogWrite(INNER, 255); delay(DELAY); analogWrite(OUTER, 0); analogWrite(MIDDLE, 0); analogWrite(INNER, 127); delay(DELAY); analogWrite(OUTER, 0); analogWrite(MIDDLE, 0); analogWrite(INNER, 0); delay(PAUSE); } }

Tags