PYLE Microphone Stand - replacement for leg tripod junction
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Replacement part for PYLE microphone stand.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 14
- Makes
- 0
- Views
- 112
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Music
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Replacement for broken oem plastic part for a PYLE microphone stand bought on amazon: https://a.co/d/e0lh1k3
Requires one 8mmx1.25 heat-set inset to use the original locking knob. The OEM part had a bevel taper on the top surface which was presumably for appearance. This replacement part is flat so it can be printed with that surface on the bed to eliminate the need for any support material. The leg pivot holes are sized for 0.187(3/16)/5mm fasteners (OEM stand is riveted, which was the cause of the plastic part breaking).
The locking pad fits into the recess in the bore and should be printed with 25% or higher infill (pref. solid).
Printed on a Core ONE in Sunlu PA6-CF at 100.5% with 4 tops, bottoms, perimeters and 20% fill using 65g of filament.