1 / 6
FOGO bin holder — image 1
1 / 6

FOGO bin holder

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

FOGO bin for Rockingham area, apparently other councils also use it so let me know if you council uses the same

Rating
3 / 5
Likes
0
Downloads
13
Makes
0
Views
91
Reviews
2

Updated at source:

Model information

Category
Kitchen
License
Standard Digital File License

Description

When you print it make sure to print it on its side as shown in the slicer photo I uploaded, it's important that it prints standing up as to place the layer lines away from any of the directions that force will be applied to the holder, it prints perfectly fine standing up provided you give it enough of a brim. I would also suggest 3-4 walls and to NOT use arachne wall generation as the print in place spring just works better with classic.

Known supported FOGO bins

  • Rockingham

This bin works for Rockingham FOGO bins, I am assuming my local council didn't source their own bins so maybe other places around Australia will have the same bin, if your not from the Rockingham area and this fits your bin please let me know so I can update the listing

Parts

Any screw that fits should do, but I used a 6g 18mm countersunk timber screw (I think it was this one: https://www.bunnings.com.au/zenith-6g-x-18mm-stainless-steel-long-thread-countersunk-head-timber-screws-14-pack_p2420096). The important part is to make sure the screw isn't too long but you will want to have at absolute minimum 10mm otherwise I would be concerned the bin might jump off one day.

Instructions 

When installing the bin find the placement you want, screw in one screw onto the face of the fogo bin clip such that your screw is being installed into the side of the clip which is countersunk so that the screw ends up flush with the clip after installation.


When installing the bin onto the clip, place it in the little gap, this is so that if your kid decides to upper cut the bin it doesn't come flying off, it might be slightly tight on first install but should be easy once you've done it at least once. Please let me know if it's too tight or too loose for you in your feedback if you can get the time.
 

From there use a spirit level to ensure the bin clip is level and screw the second screw in. See photos for examples.
 

(I’ll upload photo later mobile site doesn’t want to work)

Selling this model

Please reach out if you want to sell this print on marketplace or other places, most likely it will be fine I just don't want to be competing with my own design in the few local places I do sell it. Feel free to print it and hand it out for free to anyone

Tags