1 / 2
Storage Case for TEMU Drill and Tap Bits or other small parts
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
The bits come in a plastic bag. Not good for the bits. This case has separate compartments for the bits.
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 36
- Makes
- 0
- Views
- 169
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution
The compartment sizes for the bits are 60mm x 11, 9, 8, 8, 8, 8. The case lid has runners on the side that ride into the grooves in the case. At the end of the lid is a small lip the goes over the edge of the case to secure it in place. By sliding the lid down halfway and tilting over allows the bits to tilt over for easy removal.
I used basic generic settings for PLA. Allow parts to sufficiently cool before removing them from the built plate or it could distort and not fit. From experience.