1 / 2
RatRig EVA NeoPixel Mount
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Mount a NeoPixel stick to a RatRig EVA extruder
- Rating
- 0 / 5
- Likes
- 24
- Downloads
- 102
- Makes
- 0
- Views
- 1,349
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution
Hardware:
- Two M2 x 6mm screws
- Some cables and connectors to wire up the LEDs (I used dupont connectors and an angled pin connector soldered to the LED stick.)
- Adafruit NeoPixel stick
Software:
- Klipper LED Effect (Syntax for configuring to a Raspbery Pi pin is
rpi:gpio23.)
Note that there's an outstanding issue using NeoPixels with Klipper in some configurations. I had to connect the data pin to the control board's RGB pin (PE6 on SKR 2).