Dual 50KG Load Cell & HX711 Holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a dual 50 KG load cell and associated HX711 amplifier holder. I'm using it to detect the presence in the bed…
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 17
- Makes
- 0
- Views
- 259
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution
This is a dual 50 KG load cell and associated HX711 amplifier holder. I'm using it to detect the presence in the bed of a handicapped relative. My intention is to use the setup to trigger a Zigbee door switch or leak detector so I can create whatever routines or automations I choose. Because the load cell wiring is somewhat fragile, I also made a 1.5mm cover. It can be attached to the bottom with a few spots of super glue.
I haven't fully settled on the processor and will likely end up with an ESP32 and a small relay with dry contacts to operate the switch/sensor. The basic Arduino sketch runs fine on an Adafruit Metro Mini and most of the ESP32 variants.
Print Settings
Printer Brand:
Creality
Printer:
Ender-3 v2
Rafts:
No
Supports:
No
Resolution:
.12 layer height
Post-Printing
50 KG Load Cell holder and cover
Category: 3D Printing