Mini Obi-Wan Kenobi

Description

A mini of Obi-Wan. If you do not have any beige filament, white will be fine. With the application of make up, it will look better than just using skin colored filament. You will also need 6x2mm magnets, although there is a pin you can print if you do not have any.

Instructions:
 

Print everything. You will be left with a messy body, but not to worry, it cleans up nice using snippers. Be careful please.

Insert the legs, don't be afraid to press hard. No glue necessary

Apply the magnets, to avoid polarity, confusion use a pillar of them.

Speaking of the head, this is the creepy unholy face you get. Apply the beard which clicks into place.

Apply a little glue and attach the glorious hair

Apply the eyebrows. If you do not have Magic Glue (melts PLA chemically with minimal fuss), be very careful using super glue. Apply a small droplet using a purge line. Leave it to dry

Apply another droplet on the edge, and using a thin object, press and glue it to the face. I made a bit of a mess, but I only notice it now thanks to the wonders of digital photography.

Next up is applying make-up, raid your GF's or moms make up kit and get a corrector and a fine bristle brush. DO NOT do what i did here, because it will leave spots.

Apply very little make up on the brush, and swipe it on your hand. Diffuse the rest on the face of the model, very little is necessary to avoid the “vampire” look beige filament gives. Don't worry if you mess it up, a wash with soap and water and dry it before giving it another try

Apply eyes, they can only fit one way and “feel” correct

All that's left is to insert the arms, assemble the light saber (simply fold it and insert the blue part) and put it in the hand. You may need to sand the light saber a little.

Any issues, send me a comment!