VW Eurovan ScanGuage II Mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
ScanGauge II mount for the VW Eurovan / Winnebago Rialta
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 8
- Makes
- 0
- Views
- 130
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Automotive
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
ScanGaugeII can help you monitor your VW Eurovan/Rialta most vital systems and provide the kind of real-time information you’ve been missing. The mount is positioned on the dash, utilizing the small well and the cigarette lighter space.
I used the ScanGauge II mounting C (tilt & angle) for my Rialta.
2x 3mm Brass Insert
2x 10mm Hex Head Screw
The case that holds the scanguage snaps onto the base that is screwed into the dash mount. You will need to remove the trim, remove the storage compartment above/right of the ashtray, snap in the dash mount, reattach the trim, and screw the base to the dash mount (the trim basically keeps it attached to the dash). Run the OBDII cable to the left of the steering column (the bottom cover below the steering wheel is held in by three screws from the bottom) and route it to the dash mount (it attaches to the rear of the scanguage)
Note: this covers the cigarette lighter, so I removed it and wired it to a dual USB charging port that I installed in one of the switch bays above.
Filament: ABS/ASA
Infill: 25%
Supports: No
Brim: No