BTT Filament Runout Sensor EVA Anti-Oscillation Clip
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Secures a BigTreeTech Filament Runout Sensor onto a RatRig EVA extruder.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 13
- Makes
- 1
- Views
- 526
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Public Domain
Is it a good idea to mount such a heavy filament sensor to the top of a direct drive extruder? Probably not, but I did it anyways! The very minor benefit here is that slightly less filament is left over when a roll is finished.
FWIW, I did do a ringing tower test and didn't noticed any ringing, even before running any compensation. Your mileage may vary, though.
The clip is held onto the extruder motor using a wire tie. A short M3 screw and square nut are used to compress the top of the clip onto the runout sensor. The clip gets a bit in the way of the runout sensor's plug, but the result is that the runout sensor sits slightly forward. I may update it in the future if it annoys me enough.