1 / 4
FlexHex Modular Spray Can Rack
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Simple, stackable spray can rack that uses minimal filament and requires no assembly -- just stack em and rack em!
- Rating
- 0 / 5
- Likes
- 11
- Downloads
- 56
- Makes
- 0
- Views
- 175
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Simple, stackable spray can rack that uses less than 35g of filament (PLA, per can module) and is ready to use right off the print plate. No assembly, no clips or glue – just stack ‘em and fill ’em with your spray cans.
This rack will hold standard North American spray / aerosol cans (which have an approximately 65mm diameter). The open hex pattern also allows you to mount these under a shelf with screws & washers.