V-Slot Cover
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€0.13 – €0.15 net (excluding VAT)
For file: Cover.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.14 excluding VAT (range midpoint).
- Weight reported by the author
- 1 g
- Print time reported by the author
- 10.8 min
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Parametric Cover for 2020 (and similar) V-Slot Profiles
- Rating
- 5 / 5
- Likes
- 58
- Downloads
- 532
- Makes
- 17
- Views
- 1,974
- Reviews
- 12
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- GNU General Public License v3.0
This is a snap-in-place cover for V-Slot profiles.
It is optimized to print in vase-mode with a 0.4mm Nozzle.
It will be strong and flexible enough if you use PETG.
Use a brim for good bed adhesion and if cooling is adequate it should print fine without a minimum layer time.
For different nozzle diameters and other customizations you can edit the .FCstd file with FreeCAD (there's a sheet called “Dimensions” and the Model will auto update if you modify one).
I found that the maximum height that will work with the SUNLU PETG I used is around 80mm, so the model files have this height. Any higher and the part will bend too much during printing, so detail is lost, which in turn results in an imperfect fit to the profile.
Lastly the pre-sliced file is for a Revo Hemera with a 0.4mm nozzle on an Ender 3.
Edit: Looks like @Tascanis_1277847 managed to get good results printing with the front side on the bed, too. I didn't try printing in that orientation, but you may give it a shot.
Copyright Notice:
The V-Slot profile in the .FCstd file, that was used to derive dimensions, was taken from Creality3DPrinting's GitHub and is licensed under GNU General Public License v3.0.