Dishwasher status - Clean, Washing, Dirty
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A simple status magnet for dishwasher
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 10
- Makes
- 0
- Views
- 54
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I could not find a dishwasher state magnet I liked. So I made this one.
This was designed for a single color machine with manual color change based on layer height for the "Clean Dirty Wash disk" part.
Suggest PLA at 0.20mm layers.
A pause is needed between layer 20 and 21 (4.0 and 4.2mm) on the base disk to insert captive magnets. I designed them for larger magnets, up to 3mm thick.
The center hole in the base disk is not a magnet hole. That is the hole that the Arrow disk will insert into. There is a registration pin/slot on those parts. I do recommend superglue.
The arrow is also recommended to be superglued. The tolerance should be tight, but depending on your printer might fall out.
It will be tight for a little bit as the part breaks in. Once broken in, it will spin easily, but still hold at one of the three states.