Polydryer Snapdryer Desiccant dry-in-container A-frame
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Dry your desiccant in the 3D printed container(s) you use in the box. No need to empty and refill. No mess drying.
- Rating
- 5 / 5
- Likes
- 21
- Downloads
- 168
- Makes
- 0
- Views
- 1,126
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Dry your desiccant in the 3D printed container(s) you use in the box. No need to empty and refill. No mess desiccant drying. I hated doing the empty and refill task for all my desiccant containers (10 boxes with 2 each), those stray beads go everywhere. This allows you to dry up to 8 (6+2) desiccant containers at a time on the level setting and time of your choice. The blower side dries a bit faster than the return side. I let the dryer run then just turn the box 180 degrees for the other side and restart. This is my 3rd version of this model to get it sturdy, with the correct dimensions, and airflow pattern for drying. I hope this helps a few people.
I always remove the Hydro/Temp display during drying (battery fire risk).
I used PETG for better heat settings and strength in my desiccant containers and this model. PLA+ should work fine if you only use level 1 for drying.
Not recommended for the OEM desiccant holder, no front or side vents and very small back holes.