Front Mounted Power switch for the Elegoo Centauri Carbon by N-Works
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This mod for the Elegoo CC switches the position of the power switch from the back to the front for easier access.
- Rating
- 5 / 5
- Likes
- 61
- Downloads
- 167
- Makes
- 4
- Views
- 1,407
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
!DISCLAIMER!
240V CAN BE DEADLY!
Only Build this if you know what your doing and at your own risk.
Or get someone to help you who knows what he is doing.
!DISCLAIMER!
Front Mounted Power switch by N-Works
This modification for the Elegoo CC, switches the position of the power switch from the back of the unit to the front for easier access.
Parts needed:
Printed Parts: | ||
1 | X | "Display plate" |
1 | X | "Switch holder" or "Switch holder Heat insert" |
1 | X | “Back plug” |
Additional parts needed: | ||
4 | X | Screw M3X6mm |
4 | X | Threaded Inserts M3 (Optional) |
2 | X | Cable Black 18AWG 58cm |
2 | X | Cable Red 18AWG 58cm |
1 | X | Cable Black 16AWG 58cm |
1 | X | Cable Red 16AWG 58cm |
6 | X | Female Spade Connector16-14AWG |
2 | X | Fork Connector Black SV1,25-4 |
2 | X | Fork Connector Red SV1,25-4 |
3 | X | Zip tie |
Install Instructions:
1. Screw the "Display plate" on the “Switch holder”/"Switch holder Heat insert"
2. Detach the display and unscrew the back oh it.
3. Screw the display on the "Display plate"
4. Unscrew the Bottom plate of the Printer.
5. Detach the L,N and PE cables from the two terminals and the ground screw.
6. Unscrew the Power inlet and power switch assembly at the back of the printer and pull it out.
7. Unplug the red and black cables. (The yellow one stays)
Tip: Use something pointy to push inside the hole for easier removal.
8. Rebuild the cables with the crimps and longer cables.
9. Push out the power switch. Use something flat to push in the clamps on the side.
10. Plug new cables in the power switch.
11. Route cables through the hole of the Display assembly and push in the power switch.
12. Route Cables through the hole of the display cable and attach the display.
13. Route the cables like shown in the picture and connect the 18AWG cables to the terminals.
14. Plug in the 16AWG cables in the power inlet and reinstall it.
15. Reconnect the yellow cables to the terminals and the ground screw.
16. Push in the "Back plug".
17. Screw on the bottom plate of the printer.
18. Enjoy your easy accessible power switch.
