Neon Boykisser Wall Sign
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A wall-mounted LED string boykisser sign
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 11
- Makes
- 0
- Views
- 160
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Wall-mounted
- License
- GNU General Public License v3.0
Just as the title says! FreeCAD project file included as per usual with my models!
BE WARNED, THIS IS A WORK IN PROGRESS. THE SIGN WORKS, BUT THERE ARE SOME MINOR FLAWS (the boost converter slot is too small, the wire channels aren't made that well, etc.) THE MODEL IS 100% USABLE AS IS AND IMPROVEMENTS ARE PLANNED
BoM, links to laskakit, but buy from anywhere, you can find most of this stuff on Ali:
Any 2S battery pack that fits inside.
Some wires, connectors, that sorta jazz
Transparent silicone glue
Assembly:
Print the boykisser in two parts, cutting in twain in the slicer. Front part (face, LED channels) and rear part should be printed separately (unless you can print perfect 300mm bridges)
Stack 2 parts on top of one another, insert M3 screws into LED holes to align parts, glue them together.
Insert the LED strings into channels, gluing them as you go.
Let the glue dry
Flip boykisser. Connect all the positive and negative terminals of the 130mm and 300mm strings together
Set the voltages on your converters. About 3V for the LM2596 and 10V for the MT3608. MAKE SURE YOU DON'T SET THE OUTPUT VOLTAGE ON THE MT3608 LOWER THAN THE INPUT, IT WILL FRY THE CHIP INSTANTLY
Solder time!
Solder the positive terminal of the smaller strings to the positive output terminal of the LM2596 and negative to the negative. Same with the 1200mm string and the MT3608
Solder some sorta connector (probably a JST-PH-2 if you're using laskakit parts) to 2 wires. Connect the positive end to the positive input terminals of the converters and the negative end to the rocker switch.
Solder the other terminal of the rocker switch to the negative input terminals of the converters.
Glue in your preferred 2S battery pack wherever it fits. I glued it straight on top of the wires in the center and secured it via the optional battery holder jig. I used some random 10Ah batts I had leftover from early versions of my jacket.
Add a string to either the internal mounting pillars, or to the top hole in the fluff of the boykisser to hang him on a wall.
Done!
Optionally, you can glue the 2S charger directly into the boykisser if you don't mind sacrificing one for a bit of convenience during charging.
Post makes and all that jazz. Your input is always welcome! (Seriously I have impostor syndrome someone tell me I did a good job Q_Q)
Original artist who created Sillycat, aka Boykisser: Mauzymice
Base .SVG artist: DRAKONIC