adjustment gear replacement for welding helmet
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€0.50 – €0.61 net (excluding VAT)
For file: welding helmet repair gear_0.15mm_PETG_MK3S_45m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.55 excluding VAT (range midpoint).
- Weight reported by the author
- 3 g
- Print time reported by the author
- 45 min
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Replacement part for the headband main adjustment gear of a Chicago Electric (cheap, Harbor Freight) welding helmet.
- Rating
- 0 / 5
- Likes
- 7
- Downloads
- 15
- Makes
- 0
- Views
- 106
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution
The welding helmets from Harbor Freight tools, branded Chicago Electric, are amazingly cheap, and work, so a lot of people get their start welding using them, and I expect there are hundreds of thousands of them in use. The size adjustment at the back of the head is not great, but it works. Until one of the parts breaks. Amazingly, it this part of the mechanism is well designed for disassembly and repair, if only you could get the replacement for the part which will always break (it's made of the wrong plastic, and is generally under-engineered). The helmets are amazingly cheap, and I'm sure lots of people just go buy a new one, or put duct tape on the headpiece, but having working helmet unusable because of the failure of a tiny plastic part is nuts.
Mine broke today. I repaired it just now. It's in PETG, so it might last a little longer than the original, or it might fail on the layer lines, but I can print another one.
I printed it solid, in PETG. (A rigid nylon would probably work well, too.) Print upright with supports to keep the big flange flat, and check "avoid crossing perimeters" to keep the central hole open.
To disassemble, you need to put a ballpoint pen or an awl in the holes in the back washer, and rotate it 90 degrees either direction, then gently pull the whole knob, and it will come off, releasing the spring and the inevitably broken part. Take it and all its broken pieces out, slip in the new part, and reassemble.
I haven't made the other parts of this mechanism, as they're much less likely to break, I believe. If this part fails quickly, I might need to replace the locking washer on the back, as it gets chewed up in the process of removing it. But the rest will probably last. If the main post were to break, it would be more of a problem, and that part would be pretty hard to replicate or repair adequately.