Ultenic T10 Brush gear
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
replacement gear where the brush bar is driven
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 18
- Makes
- 0
- Views
- 74
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Public Domain
vacuum grabbed something and the main brush stripped out the drive gear. I can't remember if the drive end of the brush is a hexagon or a square on this model (because I modified a few different models). If it's a hexagon, you will need to modify the brush to accept a square shaft (or re-model this). You will need to open the brush drive gear box to access this gear and be careful not to lose the idler pin and gear bearing. This model was made with a very tight fit on the idler pin so you may need to drill it out a bit (or re-model this).
printed 100% infill, no supports using paht-cf but abs would probably work too.