Quad Lock Phone Mount for 2014-2019 GM Vehicles
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Fill the hole in your dashboard with a place to mount your phone!
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 24
- Makes
- 0
- Views
- 273
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Automotive
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Overview
This tray will fit nicely in the empty "change slot" hole in GMTK2XX platform vehicles.
This does not require any tools (except a 3D printer) and there is no need to permanently modify the vehicle.
Vehicle Compatibility
It should fit on the following models, provided you have the change slot hole in your dash to the left of the steering wheel:
Year Range | Make/Model |
|---|---|
2014-2018 | Chevrolet Silverado |
2015-2018 | GMC Sierra |
2015-2019 | Chevrolet Silverado HD |
2015-2019 | GMC Sierra HD |
2015-2020 | Chevrolet Tahoe |
2015-2020 | GMC Yukon |
2015-2020 | Cadillac Escalade |
2015-2020 | Chevrolet Suburban |
2015-2020 | GMC Yukon XL |
2015-2020 | Cadillac Escalade ESV |
2019 | Chevrolet Silverado LD |
2019 | GMC Sierra Limited |
NOTE: I have only been able to test this on my own 2014 Silverado.
Materials Needed
You'll need the following to install this tray to match my own installation:
Item | Notes |
|---|---|
You'll only need two individual strips, a pack will come with plenty of spares. | |
This base will include the hardware required to attach it to the tray. | |
Configure this however you want, but the items I used are:
| |
You'll need the one that fits your phone. If you go with the MAG Head or MAG Wireless Charging Head, you'll have to get MAG Case rather than the Original |
Printing
I highly recommend that you use PETG at a minimum, heat resistance is important in this application. That said, my first iteration was black PLA and it survived a summer in the south before it warped enough that it was noticeable during use. The phone screen started to pick up more glare in certain conditions.
I'm currently using a PETG version and it's got some minor warping after a year or two, but it's not enough to notice while driving.
These are the settings that are working for me:
Prusament PETG
15% gyroid infill
I printed with supports on the bottom fillet, but that probably wasn't necessary.
Installation
Start by installing the Quad Lock 360 setup that you've chosen following their instructions. The base mount will fit into the recess on the front of the tray, and the nuts will secure it from the back.
Once you're ready, grab two of the velcro Command Strips and stick them together as straight as possible.
Remove the backing tape on one and align it to the relief on the back of the tray.
Here you can choose to either cut off the pull tabs or tuck them to the side. I chose to tuck mine to the side - but it didn't stay that way. Either approach will work, cutting the tabs being a bit more fiddly but making it harder to remove if you ever choose to do so.
Remove the rubber tray from the coin slot. I stashed mine in the center console in case I ever sell the truck.
Peel off the other adhesive backing and press the tray firmly into the hole in your dashboard. Give it a gentle tug to make sure it's sticking properly.
Finally, run a charging cable however you like if you chose the charging version of the mount. I tucked my cable behind the dash at the base of the steering wheel and pulled it out by the 12V port.
