Pop-out cellphone stand TPU/PETG hybrid, no AMS required
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A simple, customizable pop-out attachable PETG/TPU phone stand designed to be thin compatible with wireless charging
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 5
- Makes
- 0
- Views
- 40
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Gadgets
- License
- Creative Commons — Attribution — Noncommercial — NoDerivatives
Athough the original model worked well (and the PETG could bend perpendicularly at the joints hundreds of times without failing), there was a weakness -- if the legs were twisted/torqued, the living joint would tear.
As a result, I tried a number of other designs, but found them lacking. TPU alone was too flexible to hold the phone up. I started experimenting with combining materials. When I tried to add TPU at the joint layers or either to the top or bottom, the stand became significantly less stiff and would bend. However, after playing around with joint placement, I found that sandwiching the TPU layer between PETG layers, it retained its stiffness and had significantly improved durability at the joints without needing to be thicker.
I recommend printing at 0.2 height layers with PETG and in the slicer add a filament switch to TPU at layer 0.8 and back to PETG at layer 1.2mm.
This can be personalized with writing in the slicer (see pdf).
The kids can draw on it and it can become a personalized art project.
I use double sided nano-tape for adhesion. You will need to attach the top two boxes/corners and the bottom of the middle leg (marked by an "X")
It pops out most easily if you pull up at the top first (see PDF).