1 / 2
Yet another standing fan blade design — image 1
1 / 2

Yet another standing fan blade design

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

My fan blades broke so I decided to print my own. Works fine with 2/3/6 blades, although two blades is a bit noisier.

Rating
0 / 5
Likes
5
Downloads
91
Makes
0
Views
480
Reviews
0

Updated at source:

Model information

Category
Living Room
License
Creative Commons — Attribution — Share Alike

My fan blades broke so I decided to print my own. Works fine with 2/3/6 blades, although two blades is a bit noisier.

The blades themselves are printed laying flat. Lots of support, but they came out okay-ish, and I don't hear much difference.

It's a bit smaller than the original, but it works just fine, not noisy on low speeds which is what I use.

IMPORTANT: my fan used a roll pin through a hole in the axle for locating the blade, that's what the slot in the base is for. If your fan uses a D axle, this won't work.

Also could be important - check which direction your fan spins and mirror the blades accordingly.

The hub has 0.005 mm wide cuts for reinforcement, those may disappear depending on the gap close settings in your slicer. I am not sure they are needed, I just added them because I was paranoid about strength.

So far it worked for 18 days and hasn't failed yet.

Tags