T45-T60 Power Armor Helmet -Can Holder (Two types)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Can Holder for 0.5L Cans (12oz+330ml can inserts)
- Rating
- 0 / 5
- Likes
- 21
- Downloads
- 101
- Makes
- 0
- Views
- 312
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Gadgets
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
T45-T60 Power Armor Helmet - Can Holder (Two types)
These helmets are a mix between T-45 and T-60 power armor from the Fallout Game and TV series, I'm afraid not all the details will be completely accurate.
Fits long EU cans with a capacity of 0.5L. You can also use my insert for 12oz or 330ml (slim) cans (link below)
Recommended print settings: PLA, 0.2mm layers, 2walls, 8%gyroid, brim, Automatic (30°) tree support, It is necessary to set supports even under some small parts and tubes.
Remove the supports wisely, very carefully, and ideally with pliers. It is better to spend 5 minutes removing the supports than to have a ruined piece.
#1

#2

Here is the link to my model of the insert that you can use in 0.5L holders with your 12oz , or 330ml slim cans, and 10mm riser if you want better access to the top. They are scalable, so you can make them smaller or larger in your slicer.
https://www.printables.com/model/1322047-can-holder-riser-inserts-12oz-slim-330ml-scalable
Happy printing:)