Sky Watcher Heritage/Virtuoso GTI 150P Focuser Upgrade
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Adapters to add an improved focuser and eyepiece holder to the Sky Watcher Heritage and Virtuoso 150mm telescopes.
- Rating
- 5 / 5
- Likes
- 11
- Downloads
- 200
- Makes
- 2
- Views
- 1,375
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Physics & Astronomy
- License
- Creative Commons — Attribution
Note: I've added another version of this mod that doesn't require cutting the focuser tube, but adds an additional 5mm to the length. The adapter is called no_cut_m58_focuser adapter.
This is a set of adapters to add a 25-55mm helicoid focuser and improved eyepiece holder to Sky Watcher Heritage and Virtuoso GTI 150P telescopes. This modification requires permanent modification of your telescope, namely cutting the focuser tube.
The parts are designed to be printed with 0.2mm layer height. Make sure to print outside walls first to ensure dimensional accuracy for the very fine threads. I used black Overture PLA Plus. The eyepiece holder adapter STL includes a support. After it's done printing, you'll need to knock the support out.
Required components:
M58-to-M58 25-55mm helicoid focuser. I strongly recommend buying one that specifies a brass core.
Svbony M42 Focuser - https://www.svbony.com/products/m42x0-75-reflector
Flush cut saw - https://www.harborfreight.com/6-12-in-flush-cut-saw-71141.htm
File - https://www.harborfreight.com/8-inch-half-round-file-96629.html
Spring clamp - https://www.harborfreight.com/spring-clamp-set-14-piece-56497.html
Instructions:
1) Print the cutting jig block and clamp it to the focuser tube after removing the factory eyepiece holder. Carefully cut the tube using the flush cut saw. Clean up any high or rough spots with the file.
This should be done with the OTA in the collapsed position to keep debris from getting inside the telescope.
2) Print the focuser adapter and thread it onto the focuser, being extremely careful to avoid cross-threading.
3) Print the EPH adapter, remove the support and carefully thread it onto the focuser. Then take the EPH from the Svbony focuser and thread it into the EPH adapter.
4) Place the assembly in the freezer for half an hour. Take it out, re-tighten all the threaded connections, then thread it into the focuser tube on the telescope, cinching it down firmly without over-tightening. (Cooling and then tightening/installing the assembly helps make sure the parts don't loosen when the scope is used in cold weather.)
5) Print and install the stopper clips on the ends of the extension struts. (I made these a bit longer than the length added by the new focuser assembly to provide a bit of extra back-focus. This improves compatibility with some Barlows and eyepieces.)
6) Collimate your scope, preferably with a laser collimator. If you can't get the dot to remain in the circle while focusing in and out, something is threaded on crooked. Remove and re-install each piece (collimating between each) until the dot stays within the circle. Some movement is unavoidable due to the nature of the focuser, but you should be able to get it to stay withing the circle consistently.
7) Optional but recommended - Print and install the dust plug.
8) Also optional but recommended - print my clip-on light shroud: https://www.printables.com/model/1569521-sky-watcher-heritagevirtuoso-150p-clip-on-shroud
