1 / 4
[Gen2 Drawer] Male-to-Female Rail Joiners/Connectors — image 1
1 / 4

[Gen2 Drawer] Male-to-Female Rail Joiners/Connectors

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Allows for overhang-bins without additional rails. Also secures existing bins together, reduces play, and create padding

Rating
0 / 5
Likes
0
Downloads
12
Makes
0
Views
86
Reviews
0

Updated at source:

Model information

Category
Organizers
License
Creative Commons — Attribution

Had some stabilizers already installed preventing the installation of corner rails/drawers, and honestly I'm just lazy to remove them.

Still wanted to make use of the full space width for the drawers, so I made this adapter to extend the reach of bins below the stabilizers without the need for rails (as a temporary solution at least). Originally it was only meant for overhanging lighter bins, but found a couple of other traits that might make it useful for others.

Installation Tips

  • MTF connector pieces can be slide into either the top or bottom of the existing bins/rails.

  • Do not hang heavy bins directly on the rails right away.

    • Causes play/sagging on the adapter.

    • Instead, ensure the taller/heavier bins are centered or is supported by a direct rail above.
      (This will allow lighter bins to lean on the center bins as support).

  • Two variants of W3 models are provided to accommodate different bed sheet sizes.

    • [XL] Full-Sized: Can print as a single on Prusa Core L/XL or similar sizes.

    • [CORE] Split into two smaller pieces that can fit on Prusa Core ONE+ (~250×220mm).

      • Fit 2 pieces together as shown below when sliding it into the bins.


Tags