1 / 12
Creality K1 Max Active Carbon 92 FAN Hepa Filter Adapter
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Creality K1 Max Active Carbon 92 FAN HEPA Filter Adapter to update the rear output with an additional '92mm FAN' +…
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 11
- Makes
- 0
- Views
- 160
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial
Creality K1 Max Active Carbon 92 FAN HEPA Filter Adapter to update the rear output with an additional '92mm FAN' + 'HEPA Filter'
- The adapter adds about 48mm distance (120mmx120mm)
- No screws required (easy attachment)
Requirements:
- Matching HEPA filter (same size as standard active carbon filter)
- 92mmx25mm standard 2 pin fan with about 100 m³/h airflow or higher
- needle file for part finishing
- tesa duct tape or similar
Instructions:
- Buy relative cheap supported active carbon/HEPA13 filter (2 or 5 peace from AlliExpress. Screenshot attached)
- Make sure to provide a 92mm standard FAN with sufficient airflow (I used a cheap 24V FAN with about 100 m³/h airflow or higher)
- Provide a needle file for part finishing
- Print all parts at once (Print Setup idea screenshot attached, but I'm sure there are better options. The hook attachment is key)
- Part finishing: !!Do NOT use force on part attachment and break the hooks!! Use the needle file FIRST to finalize the hooks and hook notches to make sure NO leftover material blocks the hooks from attachment until the attachment works smooth and snug without force
- Remove existing active carbon filter and the screws from rear FAN and attach part I (optional: Use matching washers)
- Install FAN into part II and use any desired cable outlet as required
- Install active carbon filter back into part I (There should be still sufficient space)
- Install part II FAN cartridge (make sure the active carbon filter ribbon does NOT touch FAN surface while turning)
- Install part III and attach the HEPA 13 filter
- Verify function
- Seal the box using tesa duct tape or similar
- Optional: Provide any valuable feedback to me or community
Category: 3D Printer Accessories