Latch for Hyper Tough 3 Gallon Wet Dry Vac
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Somehow, we lost the latches for our little wet/dry vac. First it was one, then it was both.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 12
- Makes
- 0
- Views
- 77
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Mechanical Parts
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Print in place as loaded.
No added support needed.
Supports built in.
ABS is what I printed it out of. Other filaments may vary.
.4 nozzle
.24 first layer
.2 layer height
4 walls
40% infill of choice
After printing, just work the latch, and the support should break free and pull out of the mechanism. Then remove the middle support from the hinged part. Attach to the vacuum like the original. If your printer isn't tuned well, then you may have difficulty. I've calibrated Flow, Pressure Advance, X-Y hole comp, Skew, etc. The model prints extremely well on my printer. I've attached the step file in case you want to widen the clearances.