2025 honda accord trunk floor support
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
2025 honda accord trunk floor support
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 5
- Makes
- 0
- Views
- 118
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Automotive
- License
- GNU General Public License v3.0
11th generation honda accord hybrids (2023-2026+) don't come with a spare tire but you can diy add one.
Doing so means removing the foam that supports the trunk floor and you have to do something to then replace that support.
What I did was to lay the original foam (larger side down) on top of a sheet of 1/4" hardboard (menards/homedepot) and traced it. I then added 2" to each of the left and right sides along the original trace (you can see this in one of the photos) and cut out the new larger shape. This will produce an ok floor (supported in the front and sides of the tire-well) - i reinforced the middle with a post that sits on top of the spare-tire-hold-down.
This model includes 4 files:
Base - this nests nicely on top of the spare-tire-hold-down.
Shim - this makes the total height of the support column adjustable. I think I printed 4 and used 3 (2 might have been enough).
Main - This is the part of the support that screws to the bottom of the hardboard
Template - this lets you drill mounting holes in the hardboard accurately.
Assembly:
1: Assemble the post: I used a 1-5/8" wood screw for assembly. Assembly order is like this: [Screw][Base][Shim][Shim][Shim][Main]. Press a 10mmx3mm magnet into the top/center hole of the main model.
2: Press a 10mmx3mm magnet into the center hole of the template file. Put the template on top of the main model and note which side is up when the magnets attract.
3: Put the assembled post in place on top of the tire-hold-down.
4: Carefully place the cutout hardboard where you want it to sit over the tirewell.
5: Lay the template on top of the hardboard approximately where the support is. Move it around until the magnet centers it. Use a pencil (or spray paint) to mark hole locations on the hardboard. (Hole clocking doesn't matter because support post clocking doesn't matter.)
6: Drill holes where you placed marks above then use screws to mount the post to the hardboard.
7: Add or remove shims to taste.
Note: I also added a 1" rigid foam support at the back that sits directly on the tire.
The spare-tire-hold-down model is available here: