Hotend accessory box for the Elegoo Centauri Carbon

I wanted to keep all the accessories and nozzles for my Elegoo Centauri Carbon in one place, but I couldn’t find any design that included everything, so I made this remix to store it all. That’s why I used the hotend storage box by @TLabCustom_3553308 (https://www.printables.com/model/1428379-elegoo-centauri-carbon-hot-ends-set-box) as the base, and added the two accessory plates from @Kuzma666_3755692’s design (https://www.printables.com/model/1489532-elegoo-centauri-carbon-box-with-drawers-for-elegoo), which were originally intended to work as a pull‑out drawer. Now all the hotend spare parts stay neatly organized and stored in one safe place.

The tolerances are quite tight, so you may need to adjust them a bit if something doesn’t fit at all. This setup worked well for me printing at 0.2 layer height with 4 perimeters. Infill doesn’t really matter, but 8% gyroid worked fine in my case.

The original box design uses 1.75 mm filament pieces as hinge pins. You might need to clean the holes with a tool (I used an Allen key) to get them in, since I preferred a snug fit.

I’m including an image of @Kuzma666_3755692’s design to show the full range of accessories it supports, since I didn’t have any temperature sensors on hand. I hope this isn’t an issue for the author.

I also want to apologize for publishing this as a new model (IT IS NOT). I’m not sure what’s going on, but unless I upload it this way, Printables won’t let me publish it as a remix because it detects license incompatibilities. I don’t get it — both models allow remixing and sharing with attribution.