Catch Arena for Castle Dice Tower
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I long ago broke the gate off of my print of the Castle Dice tower by LennartS. I wanted a nice arena that would slide…
- Rating
- 5 / 5
- Likes
- 19
- Downloads
- 93
- Makes
- 1
- Views
- 791
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Board Games
- License
- Creative Commons — Attribution
I long ago broke the gate off of my print of the Castle Dice tower by LennartS. I wanted a nice arena that would slide in to place and prevent my dice from shooting across the table. You may have to sand down the nubs that used to hold the gate in place to get this to fit, it's very tight.
Print Settings
Printer Brand:
Prusa
Printer:
I3 MK3S
Rafts:
No
Supports:
Yes
Resolution:
0.2
Infill:
20
Filament: matterhackers PLA jet grey
Notes:
Supports are only needed at the very end of the rails where they overhang to meet the original model. I use support enforcers in prusaslicer so there's only about 1cm wide support towers under those two areas.
Category: Toy & Game Accessories