LOQUE Ghost S1 PSU Sag Support
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
The PSU bracket sags over time due to the cantilevered design and <3mm thickness. This small part aims to correct that.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 7
- Makes
- 0
- Views
- 59
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This was designed for the Cooler Master 850SFX Gold PSU, if this does not fit feel free to remix or discuss with me how much of a gap exists. Not sure if this will work with Raw S1 let me know in the comments.
There are two versions of the bracket, a heli-coil and heat-insert version. M3x2D heli-coils is what i suggest or M3 x D4.6 x L4 heat-inserts. If would like to use another type feel free to edit the model to adapt it to your needs. As far as other hardware goes, two more M3x6 countersunk screws will be neccessary.
I would not suggest using pla for this part or any low durometer tpu. Any other polymer is fine. Heat-inserts are meant for most general filament types as it should be quite easy to warm them up. However, if you wanna use ppa or pps which mechanically creeps the least, heli-coils would give one an easier time. This part can also be made of metal if one feels the need.