1 / 4
BMW N57 ZF8HP70 mock up transmission and LS1 adapter — image 1
1 / 4

BMW N57 ZF8HP70 mock up transmission and LS1 adapter

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Files to print a mock up trans and adapter to LS1

Rating
0 / 5
Likes
7
Downloads
132
Makes
0
Views
564
Reviews
0

Updated at source:

Model information

Category
Automotive
License
Creative Commons — Attribution — Noncommercial

I am doing an LS1 ZF8HP70 swap into a BMW E39 and wanted a mock up motor and trans to make initial test fitting a lot easier. Refer to my other models for the LS1.

I found a good quality 4WD trans scan and some partial scan data of a 2WD so grabbed the rear section and merged them together. The trans mount section is lost and replaced with a blended section. Also the model is missing the input shaft and cooler fittings as I didn't need those. There is no provision for a starter motor in this design.

Printed at 0.3 layer height with 8% infill. About 5 rolls of filament. Sections are precut to suit my K1 Max mostly. 

Adapter plate is a simple model using the rear of the block and the front face of the trans, aligned and merged together. Heated inserts can be used in the trans bellhousing however holes will need to be drilled for this