Chomper (Pacman inspired) Money Box No AMS
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A Pacman styled moneybox
- Rating
- 2.5 / 5
- Likes
- 15
- Downloads
- 64
- Makes
- 1
- Views
- 218
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Other Art & Designs
- License
- Creative Commons — Attribution — Noncommercial — NoDerivatives
Here is a pacman style Money Box I made, the same as the other pacman model, but this one has a bung in the bottom and a coin slot.
There is also a ghost moneybox a ghost storage jar and a pacman style model
Printed with no supports......just!
When preparing the eys I suggest you file and sand all the bottom edges, then glue the little yellow inserts in the eyeball, let it dry and repeat, then push the assembled eye through the model a few times (it may be stiff) and it will loosen up after a few goes, if you want to glue the whole eye in (I didn't bother was tight enough not to fall out) DO NOT use superglue as it dries too quick and if you misalign it you won't get a second chance! use epoxy.
I did have some small issues with the thread of the bung fitting initially, what I did was file off a bevel on the flat side of the bung, was fine then. I have edited a little since then and seems to work fine now.
I strongly suggest using adaptive layer heigt of 0.3 and smooth about 7 times in Orca Slicer to get the head smooth on the top.