Pinewood Derby Car Display Stand
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Display your winning pinewood derby car with pride!
- Rating
- 0 / 5
- Likes
- 8
- Downloads
- 45
- Makes
- 0
- Views
- 140
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Vehicles
- License
- Creative Commons — Attribution — Noncommercial
There are a lot of great pinewood derby display stands out there, but I couldn't find one that did everything I wanted. Either the angle was off or it was flat, or it required some type of support on the base of the car, which depending on the creativity of some of the designs wouldn't have worked. This is based on the standard axel length and width requirements.
This print only requires supports under the top section's center circle where the base pillar fits to ensure proper alignment and at an angle of 22.5%. If you have decent tolerances it should hold with a friction fit - however I recommend a drop of glue for good measure. #beprepared
There's not a lot of detail in this design so it doesn't take away from your masterpiece (I mean your Scout's masterpiece, of course), so you can print this at whatever layer height you want...but I recommend .2 or .3 depending on what you want the print time to be. Not a huge amount of different between the two.
Remixes encouraged. The standard file does not include text. If you want to include text or play around here's a link to the Tinkercad design.
Enjoy!