1 / 3
SBR20 End Cap with Pulley Mount (608 Bearing) — image 1
1 / 3

SBR20 End Cap with Pulley Mount (608 Bearing)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

This is a dual-purpose upgrade for SBR20 linear rails. It functions as both a safety end stop to keep your bearing block

Rating
0 / 5
Likes
2
Downloads
15
Makes
0
Views
63
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Share Alike

Overview I designed this part to simplify the process of turning a standard SBR20 rail into a motorized linear actuator. Instead of designing a complex separate motor mount and idler system, this part clips directly onto the end of the rail.

Features

  • Integrated Idler: Holds a 608 bearing to act as a smooth pulley for GT2 or similar timing belts.

  • Secure Fit: clamps firmly onto the 20mm shaft of the SBR20 rail.

  • Compact Design: Keeps the belt path close to the rail for a cleaner build.

Hardware Required

  • 1x 608 Bearing: (Standard skate bearing, 8mm ID x 22mm OD x 7mm Width).

  • 1x M8 Bolt/Screw: To serve as the axle for the bearing (or a printed pin if you prefer).

  • Clamping Hardware: M3 or M4 screw/nut to tighten the end cap onto the rail.


Print Settings

  • Material: PLA+, PETG, or ABS (PETG recommended for durability under belt tension).

  • Layer Height: 0.20 mm

  • Infill: 40-50% (High infill is needed here to resist the tension of the belt without bending).

  • Walls: 4 walls (Crucial for the strength of the bearing post and clamp arms).

  • Supports: [Check your slicer] - The bearing slot might need minimal supports depending on your printer's bridging capability.

Tags