Remote control
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Remote speed control that could be used for a electric skateboard, printed in PLA and TPU. Based on Arduino nano.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 9
- Makes
- 1
- Views
- 92
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution
Remote control, speed control printed in PLA and TPU.
HW components:
AZ delivery Arduino nano v3 mini usb, AZ nrf24L01 radio, AZ TP4056 micro-usb battery charge module, AZ MT3608 Step up module, AZ 0.96 oled 64x128 px, switch SS12D00G3 2 position SPD, spring, led diode, 6x m3 screws and threaded inserts, linear hall effect sensor SS49E TO-92S, wires. 4 6x2 magnets, 1 cell lipo battery (size about 23x40x8 mm - 1000 mAh).
Glue the TPU gasket to the remote right side.
Receiver: arduino nano, nrf24l01.
Some arduino programming needed for the remote and receiver ;-) Enjoy!