Fitbit Charger Holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Portable Devices
- License
- Creative Commons — Public Domain
This model was made to allow me to mount my Fitbit charger on to my bedside table. This watches charger is a little weird so it tends to be hanging somewhere and I wanted a solid place to be able to drop it off and pick up easily.
I have a Fitbit Inspire 3 so if your watch uses the same charger it should work, there's a picture for reference. I recommend getting a longer charging cable so you can actually route your wire to power, you can find them on ebay for cheap, the stock ones will likely be too short.
To use, feed the usb cable through the hole (note that it might be a little tight depending on if you have an original charger or not but I tested it with both and it is fine) and pull the charger through to clip it in place then stick it to whatever surface you like with some double sided tape (3M clear recommended).
I printed in PETG but whatever you have will work. Print time on my P1S was about 20 mins total.