Subaru Eyesight Headlight Sensor Dashcam Mount Rove Stealth 4k

I took the work done by https://www.printables.com/@AJQuick and did some adaptations. This is the second adaptation I did, but feed mostly from my previous model (which I adapted from AJQuick). I needed to do a second adaptation because after 5+ years of my original remix (to be used on Type S camera) we replaced the camera from for a Rove Stealth 4k

My previous model that worked for u for Type S camera (and its rail) can be found here: 

I kept the same spirit, which was that  I did not wanted to use tape or glue to secure this to my wife's headlamp sensor, I wanted to create some way to lock it on such way that would be removable.

The adaptations I did were

• retained the 4 “legs” with cuts to receive tie wraps (2 horizontal on the back)

• Removed the rail that I added on the previous model for the type S

  • Previously I had removed for my previous remix the one for BlackVue

• I added a U shaped receiver with a square hold to use the screw that came with the Rove

I printed back then on my Prusa Mk3 printer on PETG (You need that thing to stand heat of the car on a sun day) and the parameters were like this

Nozzle / Layering

• Nozzle: 0.4 mm

• Layer height: 0.24 mm

• Initial layer height: 0.28 mm

Walls / Shell

• Wall loops: 5 

• Wall thickness: ~2.0 mm

• Top shell layers: 6

• Bottom shell layers: 6

• Top/Bottom pattern: Monotonic 

• Embed walls into infill: ON 

Infill

• Infill density: 25–30 % (30% if you want absolute rigidity)

• Infill pattern: Gyroid

• Infill line multiplier: 1.0

Enable Supports