Coping Saw V.2
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
3d printed coping saw, you need 4 M4x20mm screws, and some cordage.
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 15
- Makes
- 0
- Views
- 146
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial
Print at 100% infill.
I did mine out of ABS but PLA+ or nylon would probably be best.
You will need:
-Four M4x20mm bolts
-Some type of cordage / string.
Assembly:
>Screw sides to the handles with M4x20 bolts. Screw from handle to the side.
>Screw the 6.5 inch coping saw blade to the side pieces using M4x20 bolts.
>Place the middle divider between the sides.
>Tie your cordage into a long loop, fold it onto itself until the loops are about 7-8 inches long, and put it in the notches at the top.
>Put the tightening bar between the cordage and twist it until VERY tight. Rest it on the middle bar.
>Pluck the blade like a guitar string, it should have a high pitched note. If the sound is hollow / low pitched, you need to tighten it more.