Duender 4040mm Y Plate - Plastic and Metal combo
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Use a thin plastic and the original ender 3v2 electronics enclosure to cut out a metal bracket
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 5
- Makes
- 0
- Views
- 71
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- GNU General Public License v2.0
Uploading this as basically just ideas for another way of doing things.
This came to me when I was disassembling the Ender 3 V2 and noticed there was a lot of decent flat sheet metal stock. I happened to have a pair of aviation snips/tin snips etc on hand, and it cut decently. Definitely if you have flat pliers/vise on hand to re-straighten the metal afterwards. I also think lower profile or angled aviation snips would have been easier for the longer cuts. I printed the model out first, then just used something sharp like a wood screw to scribe the cut lines on the metal. I would align it so that you have to cut as little as possible (ideally against a corner), but if unable to, prioritize not cutting the longer sides since those are a pain. If you have a deburring tool after cutting is a great time to hit the edges.
After cutting it out, you can use the drill guides from InducedRug's model to drill.
If you happen to have all the tools on hand (tin snips, drill bits for the holes), this is essentially a zero cost way to get “metal” brackets. Compared to both PETG and ASA brackets, these have considerable less flex.
The sheet metal is roughly 1mm thick, so I still printed the original bracket in ASA, just accounting for the 1mm sheet metal.
After drilling/aligning holes, I scuffed up the mating surface between the metal and the plastic and super glue'd it together. I installed the POM wheels as “clamps” to align and hold it together.
I only did this for the Y Axis because I am lazy, but this works for the Z axis plates as well. Just remember to reduce the Z height of the plate by 1mm when printing.