Furniture Leveling Foot - 1/4” hex bolt
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Leveling foot inserts for furniture legs based on 1/4” hex bolts
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 13
- Makes
- 0
- Views
- 100
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution — Share Alike
I wanted some leveling feet for an end table I was building so I designed these inserts around a 1.25” 1/4” hex bolt and nut. You can use longer or shorter bolts if you want. A bolt shorter than 1" might not work well. To install the foot you'll need to drill a recess the leg of your furniture piece. I've tried to keep the installation required as simple as possible. A set of forstner bits is probably your best bet for drilling the recess.
Print Settings:
Body: PETG, 80% infill, no supports
Foot: TPU, 100% infill, no supports.
Print parts in the orientation given in the files.
Additional Parts:
1x 1.25" 1/4" Hex head bolt
1x 1/4" Nut
Assembly:
Press the 1/4" nut into the hexagonal recess on the bottom of the leveling leg body. Press the leveling leg shoe onto the head of the 1/4" bolt. Thread the bolt into the nut/body assembly at the wider end of the body.
Use:
To use this model you will drill a recess in the bottom of the furniture leg and then tap the leveling leg into the recess. To make the recess first drill a 7/8" (or 1") diameter hole 1/2" inch deep in the center of the bottom of your furniture leg. Then drill a 1/2" hole at least 1" inch deep in the center of the hole you just drilled. The lightly hammer the leveling foot into the recess. It is easiest to drill the recess with a drill press, but can be done with a hand drill if you are careful. A drill guide can also help. Friction should keep the foot in place, but if you want to be sure, you can apply glue to the foot and recess before tapping the foot into place.